7. Advanced
7.6.6.1 Constant Light Output (CLO)
When activating the projector with CLO enabled, the CLO will only become active after 3 minutes.
What can be done?
Constant Light Output allows to force a constant light output (set in the CLO Target ... menu) of the projector over a certain period.
This will eliminate uncontrolled light output drop caused by natural aging of the lamp. The CLO is done by automatically adjusting
the Dimmer.
How to set the CLO On or Off ?
1. Press MENU to activate the Tool bar
2. Press → to select the Lamps item
3. Press ↓ to pull down the Lam ps menu
4. Use ↑ or ↓ to select CLO Mode
5. Press → to pull down the menu
6. Use ↑ or ↓ to select CLO
7. Press → to pull down the menu
8. Use ↑ or ↓ to select ON or OFF
Image 7-104
9. Press ENTER
A bullet shows the active setting
R59770066 SIM 7Q SERIES 07/10/2013
145
To Next Page
Loading...
