7. Advanced
7.8.5.5 Blanking
What can be done?
Blanking or hard edging affects only the edges of the image and is used to frame the projected image on the screen and to hide
unwanted image information (or noise) or to put two images next to each other without overlap (soft edge).
The adjustment of hard edges is done in the same menu as the soft edge with the Edges disabled (unchecked).
How to setup a hard edge shape ?
1. Press the MENU key to activate the Tool bar.
2. Push the cursor key ← or → to highlight Display setup
3. Push the ↓ key to pull down the menu
4. Push ↓or ↑ to select S oft edge
5. Push the → key to pull down the menu.
6. Push the cursor key ← or → to highlight Edit left...
Image 7-142
7. Press ENTER
The soft edge dialog box will be displayed.
8. Uncheck all the edges
9. Adjust the soft edge as desired (same procedure as above)
10.Press BACK to return to the D isplay setup menu.
R59770066 SIM 7Q SERIES 07/10/2013
177
To Next Page
