7. Advanced
7.8.10.3.2 Calibration (for multiple projectors)
What has to be done ?
The calibration of Dynacolor consists of measuring the color values of each projector. The measurements have to be done in a
dark environment. Make sure all external lights are off (even a PC screen can produce too much unwanted light). Use a light
meter (PR655, LMT, …) and at a fixed position during the entire measurement. In the procedure below we consider a system of 2
projectors.
CAUTION: Only to be done by Barco trained and qualified engineers ! Never change the values if not needed
.
Altered color values will not guarantee optimal image reproduction.
How to calibrate Dynacolor for projector 1 ?
1. Press MENU to activate the Tool bar
2. Press → to select the Dis play setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Dynacolor
5. Press → to open the menu
6. Use ↑ or ↓ to select Adjust...
7. Press ENTER
A dialog box is displayed
Image 7-161
8. Press Calibrate in the Dialog box
A red full screen test pattern is displayed.
9. Press ENTER
196
R59770066 SIM 7Q SERIES 07/10/2013
To Next Page
