Barco SIM 7Q HB - Installing the X-Cube Filter; X-Cube Filter: Place It in Its Housing; X-Cube Filter: Put the Cover in the Right Position; X-Cube Filter Cover: Fixation Screws

8. Maintenance
8.3.2 Installing the x-cube filter
Necessary tools
Torx screwdriver T10
How to install the x-cube filter?
1. Place the x-cube filter in its housing
Image 8-7
X-cube filter: place it in its housing
Note: The seal of the air filter must point down!
2. Place the x-cube filter cover in the right position
Image 8-8
X-cube filter: put the cover in the right position
3. Tighten the four screws to fix the x-cube filter cover
Image 8-9
X-cube filter cover: fixation screws
4. Register the air filter replacement in the S ervice book
R59770066 SIM 7Q SERIES 07/10/2013
239