Barco SIM 7Q HB - Starting the Projector

5. Setup
5.4 Starting the projector
Activating the projector is only possible after the initialization period i.e. when LED1 is off.
How to start up the projector ?
1. Press the Standby button on the RCU or on the local keypad.
9
0
EN T ER
MEN U BA C K
DI G I
Z
OO M
PH A
SE
PA USE
PI P
L OGO
Image 5-5
The last selected source is displayed.
If the address setting is wrong the projector will not respond to the RCU, see the next step to set the address.
R59770066 SIM 7Q SERIES 07/10/2013 51