Barco SIM 7Q HB - Performing GLD Correction

7. Advanced
7.8.11.3.2 Performing GLD correction
Enabling Gray Level Definition
1. In the OSD menu of the projector, browse to Display setup > Gray Level Definition > Mode > On
Image 7-172
2. Press ENTER to enable GLD
Setting the GLD user interface
1. Browse to Display setup > Gray Le vel Definition > Gray Le vels... and press ENTER to open the Gray Level Definition user
interface
Image 7-173
2. Use the arrows on the Remote Control Unit (RCU) to highlight Gray Level or Image in the Source section and confirm by pressing
ENTER
- Gray Level is used to use the internal gray level patterns (advised!)
- Source must be selected to use patterns generated by an external source (different gray level required per gray range)
R59770066 SIM 7Q SERIES 07/10/2013
211