7. Advanced
7.8.5.4.2 Internal black level
What can be done ?
Internal black level can be adjusted via the projector’s software using a dialog box. The dialog box allows to add an offset to the
black level of the image in the zones outside the soft edge zones. The range goes from 0 to 255.
How to adjust the internal black level ?
1. Press the MENU key to activate the Tool bar.
2. Push the cursor key ← or → to highlight Display setup
3. Push the ↓ key to pull down the menu.
4. Push ↓or ↑ to select Soft edge and alpha beta planes
5. Push the → key to pull down the menu.
6. Push the cursor key ← or → to highlight Black level...
Image 7-138
7. Press ENTER
A dialog box will be displayed.
Black Level
Internal
Beta planes
Planes
Level
0
Image 7-139
8. Use the arrows to select the Internal check box and press ENTER
Note: It will take a certain time for the internal black lev el to be applied
9. Use the arrows or digits to fill in the desired values for the black level.
R59770066 SIM 7Q SERIES 07/10/2013
175
To Next Page
Loading...
