7. Advanced
7.6.4 Reset lamp Runtime
When to reset the lamp runtime ?
Reset the lamp runtime whenever you replace a lamp
WARNING: Lamp runtime reset as well as the lamp replacement can only be done by a Barco authorized
technician.
How to reset the lamp runtime ?
1. Press MENU to activate the Tool bar
2. Press → to select the Lampsitem
3. Press ↓ to pull down the Lam ps menu
4. Use ↑ or ↓ to select Res et runtime
Image 7-100
5. Press → to pull down the menu
6. Use ↑ or ↓ to select the lamp to be reset
7. Press ENTER
A dialog box is displayed
Image 7-101
8. Use ←or →, the numeric keys on the remote, or the keypad to enter the serial number of the new lamp (serial number 000000
will not be accepted).
142
R59770066 SIM 7Q SERIES 07/10/2013
To Next Page
Loading...
