4. Installation
4.7.3.2 Network settings
CAUTION: Make sure that a DHCP server is available in the network and works fine.
In normal conditions, the network detection takes few seconds. This means that the total time needed to go
from power ON to Standby mode is only a few seconds. This value can vary depending on the speed of the
network connection.
But when the DHCP setting of the projector is set to Yes and the network does not allow the projector to obtain
an IP address from the DHCP server, the startup time will be delayed by upto five minutes. After this time, a
time-out occurs if the network detection fails, and the projector starts up without any network connection.
What can be done?
These settings are used to set the Ethernet Communication parameters.
Following parameters are available :
MAC Address MAC Address of the projector (This is a non-adjustable value programmed into the Ethernet
board).
IP Address (Current) IP Address of the projector (This is a non-adjustable value).
Subnet Mask Subnet Mask (This is a non-adjustable value)
Gateway Gateway (This is a non-adjustable value)
DHCP
DHCP setting:
• Yes: The projector will dynamically obtain its IP address from the DHCP server.
• No: The IP address needs to be entered manually. Note that when selecting Fixed IP
the IP settings fields are enabled
IP Address Fixed IP Address of the projector : this field can be edited when Fixed IP is selected
Subnet Mask Subnet Mask : this field can be edited when Fixed IP is selected
Gateway Gateway : this field can be edited when Fixed IP is selected
Hostname Hostname : this field can be edited when DHCP is selected
How to set up the network settings ?
1. Press the MENU key to activate the Menu bar.
2. Push the cursor key ← or → to highlight Installation in the menu bar.
3. Push the ↓ keytopulldowntheInstallation menu.
4. Push the cursor key ↑ or ↓ to highlight Network settings and press ENTER to select.
Image 4-38
R59770066 SIM 7Q SERIES 07/10/2013 45
To Next Page
Loading...
