7. Advanced
7.8.6 Auto Image Setup
What can be done ?
Auto Image allows to detect automatically the characteristics of the source (total pixels per line,...) and uses this information to adapt
the image to the display.
Auto Image can adapt the image based on following data :
• Total pixels/ lines
• Start pixel/lines
•Phase
• Contrast/brightness levels
Auto Image works only for data signals.
To launch Auto Image, see Auto Image in the Image fi les menu
How to set up Auto Image?
1. Press MENU to activate the Tool bar
2. Press → to select the Dis play setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Auto Image setup
Image 7-143
5. Press ENTER
A dialog box is displayed.
Image 7-144
6. Use the arrow keys to select the desired check box and press ENTER to activate or deactivate the item.
178 R59770066 SIM 7Q SERIES 07/10/2013
To Next Page
Loading...
