7. Advanced
7.4.2 Auto Image
What can be done ?
Auto Image creates the best suited image file for the connected source.
It calculates/measures several source parameters :
• Total pixels per line
•Startpixel
•Phase
• Contrast/Brightness levels
Auto Image only works for data images.
The measure of the total number of pixels per line can be done through 2 methods
• Limited scan: a windowing system is used to allow fast tracking.
The operation takes about 20 seconds (depending on file)
• Full scan: tracking is done over the full range.
The operation takes about 1.5 minutes (depending on file)
HowtolaunchAutoImage?
1. Press MENU to activate the Tool bar
2. Press → to select the Image files item
3. Press ↓ to Pull down the Image files menu
4. Use ↑ or ↓ to select Auto Image
5. Press → to open the menu
6. Use ↑ or ↓ to select the desired file scan method
Image 7-24
7. Press ENTER
Auto Image acts on the active window. The image in the window may move and change in aspect during the
Auto Image process.
Auto Image can also be launched via the RCU with the dedicated Auto Image key.
92 R59770066 SIM 7Q SERIES 07/10/2013
To Next Page
Loading...
