4. Installation
Image 4-19
Lens: scheimpflug springs
4. Slide the lens over the 3 studs
Image 4-20
Lens positioned
5. Put a washer and a lock nut on each stud
Image 4-21
Lens fixation nuts
6. Fix the lock nuts until the
lens flange touches the lens holder plate at the 3 fixation points (nominal position).
7. Unscrew each lock nut 1 revolution and start adjusting the Scheimpflug by tightening or loosening these lock nuts
8. If the adjustment is done, screw in the smaller Allen bolts M4 (see “1” on image 4-22) until they are hand-tight
R59770066 SIM 7Q SERIES 07/10/2013 29
To Next Page
Loading...
