4. Installation
4.5.5 Connecting the lens
What must be done ?
The lens must be connected to the projector to allow the control of the Zoom and Focus and to allow data communication for the
aperture control.
Connecting or disconnecting the lens while the projector is powered can cause damage to the lens aperture and may never be done.
Therefore a warning is displayed if the lens is not connected and the projector is activated.
Image 4-23
How to connect the lens ?
1. Connect the male connector attached to the lens to the female connect
or located on the front of the projector
Tip: The side labeled TOP on the male connector must be oriented upwards.
Image 4-24
Projector lens connection
2. Secure the connection by turning and fastening the locking ring
R59770066 SIM 7Q SERIES 07/10/2013
31
To Next Page
Loading...
