5. Setup
5.6 Setting the orientation
What must be done ?
Depending on the mechanical orientation of the projector (see Projector configuration in the Installation section), the projector’s
internal settings have to be adapted.
The projector is shipped (default) with a table/front orientation.
How to set the orientation ?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Orientation
Image 5-8
5. Press → to pull down the menu
6. Use ↓ or ↑ to select the desired orientation
7. Press ENTER
The projection is adapted and a bullet shows the active configuration.
R59770066 SIM 7Q SERIES 07/10/2013
53
To Next Page
Loading...
