4. Installation
4.7.3.1 Network connections
What can be done ?
The projector can be connected to a network allowing it to be accessed from any connected network device. The Ethernet connection
can be used to upload/download projector software and/or to set up communication (TCP-packets) with the projector. This network
can be a local area network or a small dedicated network
Following operations are made possible :
• file transfer for firmware upgrade
• easy adjustment of projector
• wide range of control possibilities.
•...
The connection to the projector can be done via a crossed cable or via a HUB on the local network (LAN).
To send commands to the projector, connection must be established to port 5401.
How to connect the projector ?
1. Connect the RJ 45 male plug to the projector’s RJ 45 female connector
Image 4-36
Network connection via crossed cable (Null modem)
R59770066 SIM 7Q SERIES 07/10/2013 43
To Next Page
Loading...
