7. Advanced
Image 7-20
8. Press ENTER
A dialog box is displayed
9. Adjust the red white level (gain) on a minimal value
Image 7-21
10.Adjust the blue white level (gain) to a minimal value
Note: this m inimal value is not necessary , provided that the 2 other colors are not influencing too m uch the color to be adjusted,
in fact the aim is to minimize the e ffect of the two other colors
since there is a risk of reaching too soon the transition
(bright spots) due to the contribution of these two other colors signals.
11. Adjust the Green white level (gain) until bright spots appear on the white part of the image
12.Adjust the Blue white level (gain) until bright spots appear on the white part of the image
13.Adjust the Red white level (gain) until bright spots appear on the white part of the image
The projected image should now be noisy neutral gr
ey.
If one uses a checkerboard pattern, the bright spots should appear in the white blocks.
The input balance settings are stored in the image file, each source has its own input balance.
R59770066 SIM 7Q SERIES 07/10/2013 89
To Next Page
Loading...
