Bosch B9512G - Page 49

Control Panel Panel Wide Parameters | en 49
Bosch Security Systems, Inc. Program Entry Guide 2017.03 | 09 | F.01U.303.998
– Point Opening: Reports point opening event.
– Point Closing: Reports point closing event.
– Was Force Armed: Reports point forced armed.
– Fail To Open: Reports fail to open event.
– Fail To Close: Reports fail to close event.
– Extend Close Time: Reports extend close time event.
– Opening Report: Reports opening events.
– Forced Close
– Closing Report
– Forced Close Part On Instant
– Forced Close Part On Delay
– Part On Instant
– Part On Delay
To individually assign reports from the User category to a Route Group, click User Reports,
page 53 in the menu tree.
Test Reports
Reports in the Test category:
– Status Report
– Test Report
To individually assign reports from the Test category to a Route Group, click Test Reports, page
54 in the menu tree.
Diagnostic Reports
Reports in the Diagnostic category:
– SDI2 Device Failure
– SDI2 Device Restoral
– Watchdog Reset
– Parameter Checksum Fail
– Reboot
– Phone Line Fail
– Phone Line Restoral
– AC Failure
– AC Restoral
– Battery Missing
– Battery Low
– Battery Restoral
– Route Comm Fail
– Route Comm Restore
– Checksum Fail
– Network Fail
– Network Restoral
– Network Condition
– RF Interference
– RF Interference Restoral
– Equipment Fail
– Equipment Fail Restoral
– Service Smoke Detector
– Service Smoke Detector Restoral
– Personal Notification Communication Trouble
– Personal Notification Communication Trouble Restoral