Dante networks are subject to a restriction. Only one transmitter channel can be connected to a receiver channel at a
time (mixing signals is not possible). However, connecting a transmitter channel to various receiver channels is
possible.
Interface Dialog
The Interface window allows configuring the different interfaces located on the rear panel of the N8000. All REMOTE
CAN BUS, RS-232 and N8000 CONTROL PORT settings can be made in here. Configuring the Ethernet interface is done
under Network Settings in the General window. Additionally, Ethernet settings are also accessible from the Matrix >
Configuration via USB menu within IRIS-Net.
Element Description
IRIS-Net DIGITAL MATRIX | en 328
Bosch Security Systems B.V. User Manual 2017.05 | 3.20 | F.01U.119.956
To Next Page
Loading...
