System Defaults
Rev A 29 BBP
®
35/37 User’s Manual
Auto Cut Settings
The Auto Cut Settings default determines when the printer should pause for cutting.
Note: The auto cut settings are only available if a monochrome ribbon is installed.
If using a paneled ribbon, these settings are disabled.
There are two modes to choose from:
• Cut between labels
• Cut at end of job
In a multiprint job (e.g., serialized labels) cut mode determines if the printer should pause
between each label for cutting the individual labels. If you select Cut at end of job, all labels in
a serialized sequence print out as one long string, pausing for cutting only after the last label is
printed.
To set the cut mode:
1. Under Auto cut settings, touch the desired printing option. A checkmark is placed in front
of that option.
Supply Saver Settings
Supply Saver automatically groups labels that are narrower than the tape. This option is only
used with paneled ribbon and is disabled if using a monochrome ribbon. When this option is
selected, the printer recognizes that more labels will fit within an area that can be covered by
one panel of ribbon. It then groups the labels together to maximize how many labels will print
with that set of ribbon panels. If the option is turned off, only one label prints per ribbon set.
This is inefficient if you are printing a number of 2" x 2" labels and have 8-inch long paneled
ribbons installed.
The Supply Saver option is selected by default. If you want to turn this option off:
1. Touch Supply Saver to remove the checkmark.
To Next Page
Loading...
