Formatting a Label
Rev A 49 BBP
®
35/37 User’s Manual
Text Object Element
Text elements contain user-defined text and characters, allowing direct data entry on the label.
Only alphanumeric characters can be used in a text element. Text elements can be single or
multi-line, however the text element does not “wrap¨ text (i.e., automatically start a new line
when the label boundary has been reached).
Adding Text
When you power on the BBP
®
35/37 printer, you are presented with the Home page, displaying
the Editor (the screen where the label is created). The Editor automatically starts in text mode,
designated by the message “Type or touch here...”. You can immediately start entering data,
directly over the displayed message. The opening message disappears and your entered text
displays on the screen. A border (frame) displays around the text as it is being entered. This
border represents the text line. For a multi-line text entry, press [Enter] on the keyboard to start
a new line of text in the same text element.
To add another text element to a label:
1. Touch the Editor screen outside the current text element.
2. In the Add Object control panel, touch Text .
OR
From anywhere on the Editor:
1. In the Control Panel, touch Add Object button.
2. Touch Text .
To Next Page
Loading...
