Brother MFC-7450 - Page 266

App. 1-27
Confidential
<WSW22>
* ECM: Error correction mode
Note:
• Selector 3 is applicable to the American models only.
• Selectors 5 through 8 are applicable to the Chinese, Taiwanese and Asian models only.
• Selector 3: Call Waiting Caller ID
Setting this selector to "0" allows the user to decide whether or not to interrupt the current
call when a new call comes in. If Call Waiting Caller ID service is available in the area and
the user subscribes to it, he/she can see information about his/her incoming call on the
LCD.
• Selectors 5 through 8: Acceptable TCF bit error rate (%) (Not used.)
Setting two or more selectors to "1" produces addition of percent assigned to each selector.
If you set selectors 7 and 8 to "1," the acceptable TCF bit error rate will be 3%.
Selector No. Function Setting and Specifications
1 ECM* in sending 0: Valid 1: Invalid
2 ECM* in receiving 0: Valid 1: Invalid
3 Call Waiting Caller ID 0: Displayed 1: Not displayed
4 Not used.
5
I
8
Acceptable TCF bit error rate
(%) (Only at 4800 bps)
(Not used.)
0: 0 % 1: 8 %
0: 0 % 1: 4 %
0: 0 % 1: 2 %
0: 0 % 1: 1 %