Bruker B-ACS 60 - Page 48

48 (167) BRUKER Installation Manual Version 001
Software Commands
Instruction: HL (Horizontal Loop)
Format: HL<CR>
Description: Test loop for horizontal movement. The loop count will be dis-
played on the terminal. Pressing the CONT button when the
red LED is on stops the test.
Reply: EXECUTED!<CR><LF>
______________________________________________________________
Instruction: LB (Loop Backwards)
Format: LB<CR>
Description: Magazine loop backward. Pressing the CONT button stops the
program.
Reply: EXECUTED!<CR><LF>
______________________________________________________________
Instruction: LD (Lift Down)
Format: LD<CR>
Description: Lift down.
Reply: EXECUTED!<CR><LF>
______________________________________________________________
Instruction: LF (Loop Forwards)
Format: LF<CR>
Description: Magazine loop forward. Pressing the CONT button stops the
test.
Reply: EXECUTED!<CR><LF>
______________________________________________________________
Instruction: LU (Lift Up)
Format: LU<CR>
Description: Lift up.
Reply: EXECUTED!<CR><LF>
______________________________________________________________
Instruction: MB (Magazine one step Back)
Format: MB<CR>
Description: Move magazine one position backward.
Reply: EXECUTED!<CR><LF>
Table 7.4. Diagnostic Mode Commands