BT Micro Owner’s Manual
104
Disconnect
The system assumes that all available extension interfaces
have telephones connected to them. If an extension interface
does not have a telephone connected, ensure correct system
operation by disconnecting the extension interface using the
system programming
Use this option to functionally disconnected the extension from
the system (this option does not physically disconnect the
extension).
Page Protection
When selected the extension in question will not receive pages
from featurephone ‘Page-all’ calls.
Not Allowed to Open the Door
The selected extension cannot be used to open the door when
a call is placed over the door intercom.
Individual CDS Store
You can programme each extension to store five numbers
each. Each of these extensions will have a separate record of
calls that ring on exchange lines programmed to ring their
extensions only.
Hot Line
Extensions can be programmed so that they automatically dial a
number when they go off-hook. The number dialled can be an
extension or an external number.
Left mouse click on the field and enter the hotline number
associated with the extension. This is a telephone number up to
24 digits in length.
The user can enter another extension number, or an external
number as required (include 9 to seize the outside line).
Ringtone Frequency / Ringtone Auto Frequency
This option allows the ringing frequency to be changed from the
default 25Hz to 50 Hz on individual extensions.
If Auto Frequency is Off, then all extensions (featurephones and
POTS phones) will ring at the selected frequency.
If “Auto Detect Featurephones” is ON, then only POTS
extensions will ring at the selected frequency, (i.e. featurephone
will Auto select their ringing frequency)
Reverse Cadence
Certain devices connected to an extension position (such as
answering machines) may not ring correctly when an incoming
call is received.
This option allows the user to alter the incoming ringing
cadence (tempo) to facilitate such equipment.
Divert All
Before you leave your extension, you can divert all your calls to
ring at another extension. Alternatively, you can divert all
external calls presented to your extension to an external
number.
This function can be set for all extensions
Left mouse click on the data entry field for each extension.
Enter up to 24 digits in this field (include the trunk access digit of
diverting to outside lines).
Note
Extension diversions only apply for calls specifically to that
extension. So, or example, calls routed to the extension as part of
a general Incoming Ringing group will not be subjected to
To Next Page
Loading...
Need help?
General