Cameron Scanner 2000 microEFM - Analog Input 2 Configuration; Analog Input 2 Calibration

D-17
Scanner
®
2000 microEFM Appendix D
Analog Input 1 Calibration
Register
(Decimal)
Register
(Hex) Description
Data
Type Access Default
2567 A07 A1 - Calibration Measured 5 FP R/W 0.00
2569 A09 A1 - Calibration Measured 6 FP R/W 0.00
2571 A0B A1 - Calibration Measured 7 FP R/W 0.00
2573 A0D A1 - Calibration Measured 8 FP R/W 0.00
2575 A0F A1 - Calibration Measured 9 FP R/W 0.00
2577 A11 A1 - Calibration Measured 10 FP R/W 0.00
2579 A13 A1 - Calibration Measured 11 FP R/W 0.00
2581 A15 A1 - Calibration Measured 12 FP R/W 0.00
1
The Calibration Type register must be congured using ModWorX Pro. This register denes the type and
number of calibration points used. If altered manually, calibration points must be entered in ascending order.
Analog Input 2 Conguration
Register
(Decimal)
Register
(Hex) Description
Data
Type Access Default
2600 A28 A2 - Units U16 R/W 0
2601 A29 A2 - Time Base U16 R/W 0
2602 A2A A2 - Sampling Period U16 R/W 1
2603 A2B A2 - Dampening Factor U16 R/W 0
2604 A2C A2 - Input Cong U16 R/W 0
2605 A2D A2 - Override Enable U16 R/W 0
2606 A2E A2 - Override Value FP R/W 0.00
2608 A30 A2 - Fail Value FP R/W 0.00
2610 A32 A2 - Low Input Cutoff FP R/W 2.00
2612 A34 A2 - Low Flow Cutoff FP R/W 0.00
2614 A36 A2 - Sensor Range Low FP RO 0.00
2616 A38 A2 - Sensor Range High FP RO 0
2618 A3A A2 - Units Scale Factor FP R/W 1
2620 A3C A2 - Units Offset Factor FP R/W 0
2622 A3E A2 - Unit Description 1 LCD R/W —
2623 A3F A2 - Unit Description 2 LCD R/W —
2624 A40 A2 - Unit Description 3 LCD R/W —
Analog Input 2 Calibration
Register
(Decimal)
Register
(Hex) Description
Data
Type Access Default
2630 A46 A2 - Calibration Type
1
U16 R/W 0
2631 A47 A2 - Nominal Value FP R/W —
2633 A49 A2 - Calibration Absolute Offset FP R/W 0.00
2635 A4B A2 - Calibration Actual 1 FP R/W 0.00
2637 A4D A2 - Calibration Actual 2 FP R/W 0.00