Cameron Scanner 2000 microEFM User Manual

73
Scanner
®
2000 microEFM Section 4
Entering the Baud Rate
The baud rate is the number of bits per second that are on the serial port. This setting must match the setting
of the master device polling the Scanner 2000 or the serial port. This only applies to the Modbus
®
communi-
cations; if Modbus
®
communications are not used, leave the baud rate at the factory setting (9600).
To Enter the Port 1 Baud Rate:
Enter the Access menu. Press UP ARROW and ENTER
simultaneously.
+
Locate the Baud Rate setting. Press ENTER. The words “PORT 1
BAUD RATE” will appear in the lower
display.
Enter the baud rate. Press UP ARROW until the correct
baud rate is displayed.
Press ENTER. ”PORT 2 SLAVE
ADDRESS” will appear in the bottom
display.
To Enter the Port 2 Baud Rate:
Enter the Access menu. Press UP ARROW and ENTER
simultaneously.
+
Locate the Baud Rate setting. Press ENTER three times. The
words “PORT 2 BAUD RATE” will
appear in the lower display.
Enter the baud rate. Press UP ARROW until the desired
baud rate is displayed.
Press ENTER. ”EDIT DATE-TIME”
will appear in the bottom display.

Cameron Scanner 2000 microEFM Specifications

General

Brand	Cameron
Model	Scanner 2000 microEFM
Category	Measuring Instruments
Language	English