Cameron Scanner 2000 microEFM User Manual

60
Section 2 Scanner
®
2000 microEFM
Table 2.3—Industry Standards for Turbine Meters
Standard Applicable Section Description Notes
AGA Report No. 7:
Measurement of
Natural Gas by Turbine
Meters
Section 7-
Installation
Specications
Installation of gas turbine
meters to include ow
direction, meter orientation,
meter run connections, internal
surfaces, temperature well
location, pressure tap location,
and ow conditioning
Illustrations of recommended
installation congurations
Environmental considerations,
the use of other devices to
improve meter performance,
and precautionary measures.
This specication
applies to axial-ow
turbine owmeters for
measurement of natural
gas, typically 2-in. and
larger bore diameter, in
which the entire gas stream
ows through the meter
rotor.
API Manual
of Petroleum
Measurement
Standards, Chapter
21.1 (Electronic Gas
Measurement)
Section 1.7
-Equipment
Installation
Installation of electronic gas
measurement devices and
associated communications,
gauge/impulse lines, and
cabling
Section 1.8
-Equipment
Calibration and
Verication
Requirements for calibrating
and verifying the accuracy of
electronic gas measurement
devices
API Manual
of Petroleum
Measurement
Standards, Chapter 5
(Metering)
Section 3,
Measurement
of Liquid
Hydrocarbons by
Turbine Meters
Description of unique
installation requirements and
performance characteristics
of turbine meters in liquid
hydrocarbon service
This section does not apply
to the measurement of two-
phase uids.
Table 2.4—Industry Standards for Fluid Properties
AGA Report No. 3, “Orice Metering of Natural Gas and Other Related Hydrocarbon Fluids,” Part 3, “Natural
Gas Applications,” Third Edition, 1992, Appendix F, “Heating Value Calculation,” American Gas Association,
catalog XQ9210.
GPA 2145-09, “Table of Physical Properties for Hydrocarbons and Other Compounds of Interest to the
Natural Gas Industry,” Gas Processors Association, Tulsa Oklahoma, 2008.
AGA Report No 8, “Compressibility Factors of Natural Gas and Other Related Hydrocarbon Gases,” Second
Edition, AGA Catalogue XQ9212, American Gas Association, Arlington Virginia 1994.
W. Wagner and A. Kruse, “Properties of Water and Steam - The Industrial Standard IAPWS-IF97 for the
Thermodynamic Properties and Supplementary Equations for Other Properties,” Springer-Verlag, Berlin
Heidelburg 1998, ISBN 3-540-64339-7.
API-2540, “Petroleum Measurement Tables,” American Petroleum Institute, 1980.

Cameron Scanner 2000 microEFM Specifications

General

Brand	Cameron
Model	Scanner 2000 microEFM
Category	Measuring Instruments
Language	English