Cameron Scanner 2000 microEFM - Section 4-Configuration and Operation Via Keypad

71
Scanner
®
2000 microEFM Section 4
Section 4—Conguration and Operation via Keypad
The following parameters can be congured using the three-button keypad on the front of the instrument, as
shown in Figure 4.1:
• slave address
• baud rate
• date and time
• contract hour
• plate size
All other instrument conguration is performed via the ModWorX™ Pro software.
Because the keypad is protected beneath the lid of the instrument, the enclosure must be opened to access the
keypad. For this reason, it is important to congure these settings before installing it in a hazardous area.
!
WARNING: To prevent ignition of hazardous atmospheres, do not remove the cover while cir-
cuits are alive. The Scanner 2000 microEFM poses no hazard when opened in a safe area.
TEST ACCESS
CONFIGURATION:
Move between menus
and menu selections
OPERATION:
View next parameter
OPERATION:
View daily logs
CONFIGURATION:
Change digits and
other menu selections
CONFIGURATION:
Save configuration
settings
OPERATION:
Save totals
PRESS +
simultaneously to view
time/date, temperature,
and battery voltage
PRESS +
simultaneously to access
Configuration menu
Figure 4.1—Scanner 2000 keypad operation and calibration functions