165
The tables below list reader settings as well as symbology settings for the Linear Imager
(CCD) or Laser (SE950) scan engine.
READER SETTINGS TABLE
CCD/Laser Engine Description Default
Time-out 3 sec.
1~9 (second) Set the maximum time for decoding to continue during a scan attempt. It
applies to the following scan modes only –
Laser mode
Auto Off mode
Scan Mode Laser mode
Continuous Mode Non-stop scanning
To decode the same barcode repeatedly, move away the scan beam
and target it at the barcode for each scanning.
Test Mode Non-stop scanning
Capable of decoding the same barcode repeatedly
Alternate Mode Press the scan trigger to start with scanning.
The scanning won't stop until you press the trigger again.
Laser Mode Hold down the scan trigger to start with scanning.
The scanning won't stop until (a) a barcode is read, (b) the preset
timeout expires, or (c) you release the trigger.
Auto Off Mode Press the scan trigger to start with scanning.
The scanning won't stop until (a) a barcode is read or (b) the preset
timeout expires.
Redundancy Level None
None No redundancy means one successful decoding will make the reading valid
and induce the "READER Event".
One time, Two times,
or Three times
he higher the reading security is (that is, the more redundancy the user
selects), the slower the reading speed gets.
If "Three Times" is selected, it will take a total of four consecutive
successful decodings of the same barcode to make the reading valid.
Appendix II
LINEAR IMAGER (CCD), LASER (SE950)
To Next Page
Loading...
