Cisco A9K-SIP-700 Configuration Guidelines

RP/0/RSP0/CPU0:router(config-if-l2)# exit
Exits the current configuration mode.
Step 5 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface TenGigE 0/0/0/0
Enters interface configuration mode and configures an interface.
Step 6 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Step 7 show interface type interface-id
Example:
RP/0/RSP0/CPU0:router show interface TenGigE 0/0/0/0
(Optional) Displays the configuration settings you committed for the interface.
Configuring Local Switching
Perform this task to configure local switching.
SUMMARY STEPS
1. configure
2. l2vpn
3. xconnect group group-name
4. p2p xconnect-name
5. interface type interface-path-id
6. interface type interface-path-id
7. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
101
Implementing Point to Point Layer 2 Services
Configuring Local Switching

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English