commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Verifying MVRP-lite
These show commands allow you to verify the operation of MVRP-lite:
• show ethernet mvrp mad
• show ethernet mvrp status
• show ethernet mvrp statistics
Configuration Examples for Implementing MSTP
This section provides configuration examples for the following:
Configuring MSTP: Examples
This example shows MSTP configuration for a single spanning-tree instance with MSTP enabled on a single
interface:
config
spanning-tree mst example
name m1
revision 10
forward-delay 20
maximum hops 40
maximum age 40
transmit hold-count 8
provider-bridge
bringup delay for 60 seconds
flush containment disable
instance 101
vlans-id 101-110
priority 8192
!
interface GigabitEthernet0/0/0/0
hello-time 1
external-cost 10000
link-type point-to-point
portfast
guard root
guard topology-change
instance 101 cost 10000
instance 101 port-priority 160
!
!
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
451
Implementing Multiple Spanning Tree Protocol
Verifying MVRP-lite
To Next Page
Loading...
Need help?
General
