Step 22 Repeat Step 19 through Step 21 to add more Ethernet interfaces to the bundle you created in Step 2 .
Step 23 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Step 24 Perform Step 1 through Step 23 on the remote end of the connection.
Brings up the other end of the link bundle.
Step 25 show bundle Bundle-Ether bundle-id [ reasons ]
Example:
RP/0/RSP0/CPU0:router#show bundle Bundle-Ether 3 reasons
(Optional) Shows information about the specified Ethernet link bundle.
The show bundle Bundle-Ether command displays information about the specified bundle. If your bundle has been
configured properly and is carrying traffic, the State field in the show bundle Bundle-Ether command output will
show the number “4,” which means the specified VLAN bundle port is “distributing.”
Step 26 show ethernet trunk bundle-Ether instance
Example:
RP/0/RSP0/CPU0:router# show ethernet trunk bundle-ether 5
(Optional) Displays the interface configuration.
The Ethernet bundle instance range is from 1 through 65535.
Configuration Examples for Link Bundles
EtherChannel Bundle running LACP: Example
This example shows how to join two ports to form an EtherChannel bundle running LACP:
RP/0/RSP0/CPU0:Router# config
RP/0/RSP0/CPU0:Router(config)# interface Bundle-Ether 3
RP/0/RSP0/CPU0:Router(config-if)# ipv4 address 1.2.3.4/24
RP/0/RSP0/CPU0:Router(config-if)# bundle minimum-active bandwidth 620000
RP/0/RSP0/CPU0:Router(config-if)# bundle minimum-active links 1
RP/0/RSP0/CPU0:Router(config-if)# exit
RP/0/RSP0/CPU0:Router(config)# interface TenGigE 0/3/0/0
RP/0/RSP0/CPU0:Router(config-if)# bundle id 3 mode active
RP/0/RSP0/CPU0:Router(config-if)# no shutdown
RP/0/RSP0/CPU0:Router(config)# exit
RP/0/RSP0/CPU0:Router(config)# interface TenGigE 0/3/0/1
RP/0/RSP0/CPU0:Router(config-if)# bundle id 3 mode active
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
67
Configuring Link Bundles
Configuration Examples for Link Bundles
To Next Page
Loading...
Need help?
General
