Cisco A9K-SIP-700 Configuration Guidelines

• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring the PBB Core Bridge Domain
Perform this task to configure the PBB core bridge domain.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group group-name
4. bridge-domain domain-name
5. interface type interface-path-id.subinterface
6. pbb core
7. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 bridge group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group pbb
Enters configuration mode for the named bridge group. This command creates a new bridge group or modifies the existing
bridge group, if it already exists. A bridge group organizes bridge domains.
Step 4 bridge-domain domain-name
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
374
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring the PBB Core Bridge Domain

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English