mlacp port-priority 10
no shut
interface bundle-e107.1 l2t
description CE5 - LCR
encap dot1q 107 second 1
rewrite ingress tag pop 2 symmetric
interface bundle-e207.1 l2t
description CE2 - LCR
encap dot1q 207 second 1
rewrite ingress tag pop 2 symmetric
interface bundle-e307.1 l2t
description PE2 - LCR
encap dot1q 1
rewrite ingress tag pop 1 symmetric
l2vpn
xconnect group lcr-scale
p2p lcr-1
interface bundle-e107.1
interface bundle-e207.1
backup interface bundle-e307.1
Point-to-Point Cross-connect Configuration: Examples
This section includes configuration examples for both static and dynamic p2p cross-connects.
Static Configuration
This example shows how to configure a static point-to-point cross-connect:
configure
l2vpn
xconnect group vlan_grp_1
p2p vlan1
interface GigabitEthernet0/0/0/0.1
neighbor 102.2.12.1 2 pw-id 1
mpls static label local 699 remote 890
commit2000
Dynamic Configuration
This example shows how to configure a dynamic point-to-point cross-connect:
configure
l2vpn
xconnect group vlan_grp_1
p2p vlan1
interface TenGigE 0/0/0/0.1
neighbor 2.2.1.1 pw-id 1
commit
Inter-AS: Example
This example shows how to set up an AC to AC cross-connect from AC1 to AC2:
router-id Loopback0
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
183
Implementing Point to Point Layer 2 Services
Point-to-Point Cross-connect Configuration: Examples
To Next Page
Loading...
Need help?
General
