Cisco A9K-SIP-700 Configuration Guidelines

end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring Core Pseudowire in B-Component
Perform this task to configure the static MAC addresses under the PBB edge bridge domain.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge-group-name
4. bridge-domain domain-name
5. vfi { vfi-name }
6. neighbor { A.B.C.D } { pw-id value }
7. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 bridge group bridge-group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)#bridge group pbb
Enters configuration mode for the named bridge group. This command creates a new bridge group or modifies the existing
bridge group if it already exists. A bridge group organizes bridge domains.
Step 4 bridge-domain domain-name
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
385
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring Core Pseudowire in B-Component

Cisco A9K-SIP-700 Specifications

General

Brand	Cisco
Model	A9K-SIP-700
Category	Network Router
Language	English