Uncommitted changes found, commit them before exiting(yes/no/cancel)?
[cancel]:
• Entering yes saves configuration changes to the running configuration file, exits the configuration session,
and returns the router to EXEC mode.
• Entering no exits the configuration session and returns the router to EXEC mode without committing the
configuration changes.
• Entering cancel leaves the router in the current configuration session without exiting or committing the
configuration changes.
• Use the commit command to save the configuration changes to the running configuration file and remain within
the configuration session.
Forcing a Manual Switchover to the Backup Pseudowire
To force the router to switch over to the backup or switch back to the primary pseudowire, use the l2vpn
switchover command in .EXEC mode
A manual switchover is made only if the peer specified in the command is actually available and the
cross-connect moves to the fully active state when the command is entered.
Configuring a Backup Pseudowire
Perform this task to configure a backup pseudowire for a point-to-point neighbor.
SUMMARY STEPS
1. configure
2. l2vpn
3. xconnect group group-name
4. p2p xconnect-name
5. neighbor ip-address pw-id value
6. neighbor { A.B.C.D } { pw-id value }
7. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
121
Implementing Point to Point Layer 2 Services
Forcing a Manual Switchover to the Backup Pseudowire
To Next Page
Loading...
Need help?
General
