Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg)#bridge-domain pbb-core
Enters configuration mode for the named bridge domain. This command creates a new bridge domain or modifies the
existing bridge domain if it already exists.
Step 5 vfi { vfi-name }
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# vfi PBB-core-vfi
Configures the virtual forwarding interface (VFI) parameters and enters L2VPN bridge group bridge domain VFI
configuration mode.
• Use the vfi-name argument to configure the name of the specified virtual forwarding interface.
Step 6 neighbor { A.B.C.D } { pw-id value }
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# neighbor 10.1.1.2 pw-id 1000
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-pw)#
Adds an access pseudowire port to a bridge domain or a pseudowire to a bridge virtual forwarding interface (VFI).
• Use the A.B.C.D argument to specify the IP address of the cross-connect peer.
A.B.C.D can be a recursive or non-recursive prefix.
Note
• Use the pw-id keyword to configure the pseudowire ID and ID value. The range is 1 to 4294967295.
Step 7 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring PBB-EVPN
This section provides information on:
Configuring PBB Core Bridge Domains
Perform this task to create the PBB Core bridge domain and assign it’s corresponding EVPN EVI ID.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
386
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring PBB-EVPN
To Next Page
Loading...
Need help?
General
