RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# interface GigabitEthernet0/1/0/6
Enters configuration mode for the named interface.
Step 6 split-horizon group
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-ac)# split-horizon group
Enters configuration mode for the named interface.
Step 7 commit
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-ac)# commit
Saves configuration changes
Step 8 end
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-ac)# end
Returns to EXEC mode.
Step 9 show l2vpn bridge-domain detail
Example:
RP/0/RSP0/CPU0:router show l2vpn bridge-domain detail
Displays information about bridges, including whether each AC is in the AC split horizon group or not.
Adding an Access Pseudowire to the AC Split Horizon Group
These steps show how to add an access pseudowire as a member to the split horizon group for attachment
circuits (ACs) under a bridge domain.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge-group-name
4. bridge-domain bridge-domain-name
5. neighbor A.B.C.D pw-id pseudowire-id
6. split-horizon group
7. commit
8. end
9. show l2vpn bridge-domain detail
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
265
Implementing Multipoint Layer 2 Services
Adding an Access Pseudowire to the AC Split Horizon Group
To Next Page
Loading...
Need help?
General
