Specifies the interface type ID. The choices are:
• GigabitEthernet
• TenGigE
Step 6 neighbor ipv4 ip-address pw-id number
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor ipv4 26.26.26.26 pw-id 100
Configures a pseudowire for a cross-connect.
Step 7 pw-class pw-class-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# pw-class L2TPV3_V4_CLASS
Enters pseudowire class submode to define a name for the cross-connect.
Step 8 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring L2TPv3 Encapsulation and Protocol
Perform this task to configure L2TPv3 encapsulation and protocol.
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-class class-name
4. encapsulation l2tpv3
5. protocol l2tpv3
6. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
168
Implementing Point to Point Layer 2 Services
Configuring L2TPv3 Encapsulation and Protocol
To Next Page
Loading...
Need help?
General
