Configuring Circuit Emulation Over Packet Switched Network
Perform these tasks to configure CEoP:
Adding CEM attachment circuit to a Pseudowire
Perform this task to add a CEM attachment circuit to a pseudowire.:
SUMMARY STEPS
1. configure
2. l2vpn
3. xconnect group group-name
4. p2p xconnect-name
5. interface type interface-path-id
6. neighbor A.B.C.D pw-id
7. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group grp_1
Enters the name of the cross-connect group.
Step 4 p2p xconnect-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p vlan1
Enters a name for the point-to-point cross-connect.
Step 5 interface type interface-path-id
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
143
Implementing Point to Point Layer 2 Services
Configuring Circuit Emulation Over Packet Switched Network
To Next Page
Loading...
Need help?
General
