Configuring BGP Route Target
By default, these parameters are auto-derived from the PE's configuration:
• Route Distinguisher (RD) for global Ethernet Segment table
Default: Auto-generated RD based on loopback IP address
• EVI’s BGP Route Distinguisher (RD)
Default: Auto-generated RD based on loopback IP address
• EVI’s BGP Route Target. Default: Auto-generated RT based on EVI ID
Perform this task to overwrite the auto-generated BGP RD/RT values.
SUMMARY STEPS
1. configure
2. evpn
3. bgp
4. rd { 2-byte as_number | 4-byte as_number | IP_address | none } : { nn }
5. exit
6. evpn
7. evi evi_id
8. bgp
9. route-target [ import | export ] { 2-byte as_number | 4-byte as_number | IP_address | none } : { nn
}
10. rd { 2-byte as_number | 4-byte as_number | IP_address | none } : { nn }
11. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 evpn
Example:
RP/0/RSP0/CPU0:router(config)# evpn
Enters EVPN configuration mode.
Step 3 bgp
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
391
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring BGP Route Target
To Next Page
Loading...
Need help?
General
