Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group L2TPV3_V4_XC_GRP
Enter a name for the cross-connect group.
Step 4 p2p name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p L2TPV3_P2P_1
Enters p2p configuration submode to configure point-to-point cross-connects.
Step 5 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface GigabitEthernet 0/2/0/0/0.1
Specifies the interface type ID. The choices are:
• GigabitEthernet
• TenGigE
Step 6 neighbor ipv4 ip-address pw-id number
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor ipv4 26.26.26.26 pw-id 100
Configures a pseudowire for a cross-connect.
Step 7 pw-class pw-class-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# pw-class L2TPV3_V4_CLASS
Enters pseudowire class submode to define a name for the cross-connect.
Step 8 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring L2TPv3 Encapsulation and Protocol: Example
This example shows how to set the encapsulation and protocol for L2TPv3 tunnels:
configure
l2vpn
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
198
Implementing Point to Point Layer 2 Services
Configuring L2TPv3 Encapsulation and Protocol: Example
To Next Page
Loading...
Need help?
General
