Configures the pseudowire segment for the cross-connect.
Step 6 neighbor { A.B.C.D } { pw-id value }
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor 10.1.1.2 pw-id 11
Configures the backup pseudowire for the cross-connect.
Step 7 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring L2VPN Nonstop Routing
Perform this task to configure L2VPN Nonstop Routing.
SUMMARY STEPS
1. configure
2. l2vpn
3. nsr
4. logging nsr
5. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters the Global Configuration mode.
Step 3 nsr
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
149
Implementing Point to Point Layer 2 Services
Configuring L2VPN Nonstop Routing
To Next Page
Loading...
Need help?
General
