Establishes a bridge domain and enters L2VPN bridge group bridge domain configuration mode.
Step 5 vfi { vfi-name }
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# vfi v1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)#
Configures virtual forwarding interface (VFI) parameters and enters L2VPN bridge group bridge domain VFI configuration
mode.
Step 6 shutdown
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)# shutdown
Disables the virtual forwarding interface (VFI).
Step 7 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Step 8 show l2vpn bridge-domain [ detail ]
Example:
RP/0/RSP0/CPU0:router# show l2vpn bridge-domain detail
Displays the state of the VFI. For example, if you shut down the VFI, the VFI is shown as shut down under the bridge
domain.
Configuring the MAC Address-related Parameters
These topics describe how to configure the MAC address-related parameters:
The MAC table attributes are set for the bridge domains.
Configuring the MAC Address Source-based Learning
Perform this task to configure the MAC address source-based learning.
SUMMARY STEPS
1. configure
2. l2vpn
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
252
Implementing Multipoint Layer 2 Services
Configuring the MAC Address-related Parameters
To Next Page
Loading...
Need help?
General
