EasyManuals Logo
Home>Cisco>Network Router>A9K-SIP-700

Cisco A9K-SIP-700 Configuration Guidelines

Cisco A9K-SIP-700
694 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #676 background imageLoading...
Page #676 background image
Group ID 0x203f1e0 0x880
Interface PW-Ether10001 TenGigE0/0/0/0/6.10001
MTU 1500 1500
Control word disabled disabled
Associated Commands
• adjacency-sid
• index
• prefix-sid
• router isis
• segment-routing
The applicable segment routing commands are described in the Segment Routing Command Reference for
Cisco ASR 9000 Series Routers
Related Topics
• Overview of Segment Routing , on page 665
• How Segment Routing Works , on page 666
• Segment Routing Global Block , on page 667
EVPN VPWS On-Demand Next Hop with SR-TE
The EVPN VPWS On-Demand Next Hop with SR-TE feature enables you to fetch the best path to send traffic
from the source to destination in a point-to-point service using IOS XR Traffic Controller (XTC). On-Demand
Next Hop (ODN) with SR-TE is supported on EVPN Virtual Private Wire Service (VPWS) and VPWS with
pseudowire headend (PWHE).
When redistributing routing information across domains, provisioning of multi-domain services (Layer2 VPN
and Layer 3 VPN) poses complexity and scalability issues. ODN with SR-TE feature delegates computation
of an end-to-end Label Switched Path (LSP) to a path computation element (PCE). This PCE includes
constraints and policies without any redistribution. It then installs the reapplied multi-domain LSP for the
duration of the service into the local forwarding information base(FIB).
ODN uses BGP dynamic SR-TE capabilities and adds the path to the PCE. The PCE has the ability to find
and download the end-to-end path based on the requirements. ODN triggers an SR-TE auto-tunnel based on
the defined BGP policy. The PCE learns real-time topologies through BGP and/or IGP.
IOS XR Traffic Controller (XTC)
The path computation element (PCE) describes a set of procedures by which a path computation client (PCC)
reports and delegates control of head-end tunnels sourced from the PCC to a PCE peer. The PCE peer requests
the PCC to update and modify parameters of LSPs it controls. It also enables a PCC to allow the PCE to
initiate computations and to perform network-wide orchestration.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
650
L2VPN Services over Segment Routing for Traffic Engineering Policy
Associated Commands

Table of Contents

Other manuals for Cisco A9K-SIP-700

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco A9K-SIP-700 and is the answer not in the manual?

Cisco A9K-SIP-700 Specifications

General IconGeneral
BrandCisco
ModelA9K-SIP-700
CategoryNetwork Router
LanguageEnglish

Related product manuals