Enabling Pseudowire Grouping: Example
This example shows how to enable pseudowire grouping.
config
l2vpn
pw-grouping
Configuring L2TPv3 over IPv6 Tunnels: Example
This section provides examples for:
Configuring Neighbor AFI for Pseudowire: Example
To support IPv6 pseudowire neighbors, an AFI needs to be configured as follows:
l2vpn
xconnect group g1
p2p xc3
interface GigabitEthernet0/0/0/4.2
neighbor ipv6 1111:2222::cdef pw-id 1
Configuring L2TPv3 encapsulation and protocol: Example
For L2TPv3 tunnels, the encapsulation and protocol has to be set to l2tpv3.
The default encapsulation and protocol is MPLS.
Note
l2vpn
pw-class ts
encapsulation l2tpv3
protocol l2tpv3
Configuring Source IPv6 address for L2TPv3 over IPv6 tunnel: Example
This example shows how to configure source IPv6 address for the L2TPv3 over IPv6 tunnel:
l2vpn
xconnect group g1
p2p xc3
interface GigabitEthernet0/0/0/4.2
neighbor ipv6 1111:2222::cdef pw-id 1
source 1111:2222::abcd
Configuring Local and Remote Sessions: Example
For L2TPv3 over IPv6 tunnels, the local and remote session ID is configured under the pseudowire; however,
this configuration is optional.
l2vpn
xconnect group g1
p2p xc3
interface GigabitEthernet0/0/0/4.2
neighbor ipv6 1111:2222::cdef pw-id 1
l2tp static local session 1
l2tp static remote session 1
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
194
Implementing Point to Point Layer 2 Services
Enabling Pseudowire Grouping: Example
To Next Page
Loading...
Need help?
General
