CHAPTER 11
EVPN Features
This chapter describes how to configure Layer 2 (L2) Ethernet VPN (EVPN) features on the Cisco ASR 9000
Series Aggregation Services Routers supporting Cisco IOS XR software.
• EVPN Overview , on page 485
• EVPN Operation , on page 486
• EVPN Route Types, on page 487
• Configure EVPN L2 Bridging Service, on page 488
• EVPN Software MAC Learning , on page 490
• EVPN VXLAN Layer 2 Data Center Interconnect Gateway, on page 500
• Configure EVPN VXLAN Layer 2 Data Center Interconnect Gateway, on page 503
• Configure L2 EVPN Address Family under BGP Routing Process, on page 503
• Configure the Routing Sessions Between the DCI and ToR, on page 504
• Configure BGP session for remote DCI Connectivity, on page 506
• Configure Network Virtualization Endpoint (NVE) Interface, on page 508
• Configure a Bridge Domain, on page 511
• Configure BGP Route Targets Import/Export Rules, on page 512
• Configure Ethernet Segment Identifier, on page 514
• Configure ICCP Group, on page 516
• Enable Flow-based Load Balancing , on page 517
• Example: All-Active Multi Homing with Anycast VTEP IP Address Configuration, on page 518
• Example: All-Active Multi Homing with Unique VTEP IP Address Configuration, on page 519
• EVPN MPLS Seamless Integration with VPLS , on page 520
• EVPN Single-Active Multi-Homing, on page 532
• Virtual Ethernet Segment (vES), on page 541
• EVPN Anycast Gateway All-Active Static Pseudowire, on page 547
• CFM Support for EVPN, on page 553
• EVPN Multiple Services per Ethernet Segment, on page 553
• EVPN VXLAN Ingress Replication, on page 557
• EVPN Routing Policy, on page 567
EVPN Overview
Ethernet VPN (EVPN) is a next generation solution that provide Ethernet multipoint services over MPLS
networks. EVPN operates in contrast to the existing Virtual Private LAN Service (VPLS) by enabling
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
485
To Next Page
Loading...
Need help?
General
