Step 17 endorcommit
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# end
or
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)#commit
Saves configuration changes.
• When you issue the end command, the system prompts you to commit changes:
Uncommitted changes found, commit them before exiting(yes/no/cancel)?[cancel]:
• Entering yes saves configuration changes to the running configuration file, exits the configuration session,
and returns the router to EXEC mode.
• Entering no exits the configuration session and returns the router to EXEC mode without committing the
configuration changes.
• Entering cancel leaves the router in the current configuration session without exiting or committing the
configuration changes.
• Use the commit command to save the configuration changes to the running configuration file and remain within
the configuration session.
Configuring IP Interworking between PPP and Ethernet
Perform this tasks to configure PPP IP Interworking:
SUMMARY STEPS
1. configure
2. interface typeinterface-path-id
3. l2transport
4. end
5. l2vpn
6. xconnect groupgroup-name
7. p2pxconnect-name
8. interface typeinterface-path-id
9. interface type interface-path-id
10. interworking ipv4
11. interface type interface-path-id
12. neighborA.B.C.Dpw-id
13. pw-classclass-name
14. pw-classclass-name
15. exit
16. interworking ipv4
17. Use the commit or end command.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
137
Implementing Point to Point Layer 2 Services
Configuring IP Interworking between PPP and Ethernet
To Next Page
Loading...
Need help?
General
