Step 9 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface Serial0/2/1/0/1/1/1:0
Specifies the interface type and instance.
Step 10 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet0/0/0/1.1
Specifies the interface type and instance.
Step 11 interworking ipv4
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interworking ipv4
Configures IPv4 interworking under P2P.
Step 12 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet0/0/0/1.1
Specifies the interface type and instance.
Step 13 neighborA.B.C.Dpw-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface Serial0/0/0/0/2/1/1:0
Configures the pseudowire segment for the cross-connect.
Use the A.B.C.D argument to specify the IP address of the cross-connect peer.
A.B.C.D can be a recursive or non-recursive prefix
Note
Optionally, you can disable the control word or set the transport-type to Ethernet or VLAN
Step 14 pw-class interface-path-id
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p-pw)# pw-class class_c1
Enters pseudowire class submode, allowing you to define a pseudowire class template.
Step 15 exit
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p-pw)# exit
Exits the current configuration mode.
Step 16 interworking ipv4
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interworking ipv4
Configures IPv4 interworking under P2P.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
136
Implementing Point to Point Layer 2 Services
Configuring PPP IP Interworking
To Next Page
Loading...
Need help?
General
