• Behavior characteristics, that apply to ERP instance, if different from default values. This is optional.
This section provides information on:
Configuring ERP Profile
Perform this task to configure Ethernet ring protection (ERP) profile.
SUMMARY STEPS
1. configure
2. Ethernet ring g8032 profile profile-name
3. timer { wtr | guard | hold-off } seconds
4. non-revertive
5. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 Ethernet ring g8032 profile profile-name
Example:
RP/0/RSP0/CPU0:router(config)# Ethernet ring g8032 profile p1
Enables G.8032 ring mode, and enters G.8032 configuration submode.
Step 3 timer { wtr | guard | hold-off } seconds
Example:
RP/0/RSP0/CPU0:router(config-g8032-ring-profile)# timer hold-off 5
Specifies time interval (in seconds) for the guard, hold-off and wait-to-restore timers.
Step 4 non-revertive
Example:
RP/0/RSP0/CPU0:router(config-g8032-ring-profile)# non-revertive
Specifies a non-revertive ring instance.
Step 5 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
279
Implementing Multipoint Layer 2 Services
Configuring ERP Profile
To Next Page
Loading...
Need help?
General
