Example
Enabling Route Policy for L2VPN VPWS with BGP Autodiscovery
Perform this task to enable route-policy for L2VPN VPWS with BGP autodiscovery configuration. Only
route-policy export is supported.
SUMMARY STEPS
1. configure
2. l2vpn
3. xconnect group xconnect group name
4. mp2mp mp2mp instance name
5. autodiscovery bgp
6. route-policy export policy-name
7. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 xconnect group xconnect group name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group xg1
Enters configuration mode for the named cross-connect group.
Step 4 mp2mp mp2mp instance name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# mp2mp mp1
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
277
Implementing Multipoint Layer 2 Services
Enabling Route Policy for L2VPN VPWS with BGP Autodiscovery
To Next Page
Loading...
Need help?
General
